Low water pressure? How to find the cause
Reviewed
Where the low pressure shows up tells you most of what you need to know: one faucet, the whole house, or only the hot water. Some causes you can fix in minutes; others need your water utility or a plumber licensed by the Texas State Board of Plumbing Examiners (TSBPE).
Only one faucet or shower
- Unscrew the aerator at the tip of the faucet, or the shower head, and clean out the grit and mineral buildup. Hard water is common in much of Texas, and this is the usual cause.
- If a single fixture is still weak, its valve or cartridge may be worn. A plumber can replace it.
The whole house
- Ask a neighbor or check your water utility’s notices: the problem may be in the street, not your home.
- Make sure the main shutoff valve is fully open, especially after recent work.
- Many Texas homes have a pressure reducing valve (PRV) where the water line enters. When it wears out, pressure can drop or swing. Adjusting or replacing it is a job for a plumber.
Only the hot water
The cause is usually at the water heater: its supply valve partly closed, or sediment in the tank or lines.
Check for a hidden leak
Turn off every faucet and appliance that uses water, then look at your water meter. If it still moves, water is going somewhere. Look for damp spots, a running toilet or a wet patch in the yard, and call a plumber.
Call a plumber when
- The whole house is low and the utility says the supply is normal.
- The meter moves with everything off.
- Pressure drops suddenly, or you see rust-colored water or hear banging pipes.

