Skip to content
Tack On

Furnace or heat pump not heating? What to check first

Reviewed

A cold house in a Texas cold snap needs a quick answer. Start with the checks below; they fix a surprising number of “no heat” calls, and tell a contractor licensed by the Texas Department of Licensing and Regulation (TDLR) where to look if you still need one.

Checks you can do

  • Thermostat: set to Heat, set above the room temperature, batteries good. A blank screen usually means dead batteries or no power.
  • Filter: a clogged filter can make a furnace overheat and shut itself off. Replace it if it’s dirty.
  • Power: check the breaker for the furnace or air handler, and the switch on or near the unit, which looks like a light switch and is easy to turn off by mistake.
  • Furnace door: many furnaces won’t run unless the front panel is fully closed.
  • Gas furnace: many newer furnaces have no standing pilot. A blinking status light is an error code, explained on the label inside the door.
  • Heat pump: in very cold weather a heat pump runs longer and may switch to backup heat; short defrost cycles, with steam from the outdoor unit, are normal.

Call an HVAC pro when

  • The breaker trips again after you reset it.
  • The blower runs but the air stays cold, or the system starts and stops repeatedly.
  • You hear banging, grinding or squealing, or smell burning dust that doesn’t go away after the first run of the season.
  • The outdoor heat pump unit is covered in ice that doesn’t clear.

License to look for

A TDLR A/C Contractor license (Class A or B); the technician is registered or certified with TDLR. More: when to call an HVAC pro.

Tell us what’s wrong. Pros near you whose licenses we check with TDLR or TSBPE respond, and you pick one.

Heating & AC on Tack On