Skip to content
Tack On

AC blowing warm air? What to check before you call an HVAC pro

Reviewed

When the air from your vents isn’t cold, start with the simple checks. Many are quick, and they tell an A/C contractor licensed by the Texas Department of Licensing and Regulation (TDLR) where to look if you still need one.

Checks you can do

  • Thermostat: set to Cool, set below the room temperature, and batteries good. If the fan is set to On instead of Auto, it blows room-temperature air between cooling cycles.
  • Air filter: a clogged filter starves the system of air and can freeze the coil. Replace it if it’s dirty.
  • Breakers: the indoor and outdoor units often have separate breakers. If one tripped, reset it once. If it trips again, leave it off.
  • Outdoor unit: is it running? Is the fan on top spinning? Clear leaves, grass and anything stacked within a couple of feet.
  • Ice: if you see ice on the copper lines or the indoor coil, switch the system to Off (or Fan only) and let it thaw for a few hours before you call. Running it frozen can damage it.
  • Water near the indoor unit: many systems shut off cooling when the condensate drain backs up.

Call an HVAC pro when

  • The outdoor unit hums but its fan doesn’t spin, or it won’t start at all. Don’t reach inside: the unit holds high voltage even when it’s off.
  • Ice keeps coming back after you change the filter.
  • The system turns on and off every few minutes, or makes grinding, squealing or banging noises.
  • You suspect a refrigerant leak. Only a technician with EPA Section 608 certification may handle refrigerant.

License to look for

In Texas, A/C work for hire is done under a TDLR A/C Contractor license (Class A or B), and the technician who comes out is registered or certified with TDLR. You can look the license up on the TDLR license search. More: when to call an HVAC pro.

Tell us what’s wrong. Pros near you whose licenses we check with TDLR or TSBPE respond, and you pick one.

Heating & AC on Tack On